The module Doepfer A-190-4 an USB / MIDI-to-CV / Gate / Sync Interface and it is the replacement for module A-190-1 (which is no longer available).

The functions of A-190-1 and A-190-4 are nearly the same (Midi In, Midi Out, CV1, CV2, Gate, Clock, Reset). But the operation of the A-190-4 has been improved because a 3-digit LED display is available. The current values of all parameters (like Midi channel, reference note, clock divider) can be read back and modified by means of up/down buttons.

In addition A-190-4 is equipped with an USB interface and the external +5V supply is no longer available. Consequently the additional charges for the 5V adapter fall away.

Doepfer A-190-4 USB / MIDI-to-CV / Gate / Sync Interface Specifications:
– Width: 10 TE / 10 HP / 50.5 mm
– Depth: 30 mm (gemessen ab der Rückseite der Frontplatte / measured from the rear side of the front panel)
– Current: +200mA (+12V) / -40mA (-12V). Note: The supply current fluctuates between about 80 and 200 mA according the number of illuminated segments of the display. 200 mA corresponds to the worst case “888”.

Important notes:
– The Scale (SCA) and Tune (TUn) parameters remain unchanged when the module is initialized ! Otherwise the initialization would overwrite the adjusted values. Because of the tolerances of electrical parts there are no fixed values for SCA and TUn which are valid for all modules. The values for SCA and TUn differ a bit from module to module because of the tolerances of electrical parts. In case that the module has been adjusted totally wrong: typical values are 100 for SCA (coarse) and 55 for TUn (coarse).
– The module comes with installed bus jumpers for CV and Gate. One has to remove the jumpers if e.g. an A-164, A-190-1, A-190-2, A-190-3, A-185-1 or A-185-2 is already connected to the CV and/or gate lines of the same bus board! If the A-190-3 should be used as CV and gate source for the A-100 bus the CV and gate connections of other CV/gate sources to the A-100 bus have to be removed. Otherwise short circuits are made between the outputs of the CV or gate transmitters !
– The gate level of the Doepfer A-190-4 can be changed from +5V to +12V. For this the jumper on JP10A (behind the CV Note socket, labelled “GATE 5V JP10A”) has to be removed and installed to JP10B (behind the 16 pin bus connector, labelled “GATE 12V JP10B”).
– The module Doepfer A-190-4 is a USB device or slave in USB mode. It has no USB host function (like computers or laptops with type A USB connectors). Details on the FAQ page of our website: USB network principles.

Doepfer A-190-4 USB/MIDI-to-CV/Gate/Sync Interface Doepfer A-190-4 USB / MIDI-to-...

184,99

Approfitta della spedizione gratuita!

Immediatamente Disponibile in Magazzino, Pronta Consegna!