Messaggio pubblicitario con finalità promozionale. Offerta di credito finalizzato valida dal 01/01/2020 al 31/12/2020. Per tutte le condizioni economiche e contrattuali, fare riferimento alle Informazioni Europee di Base sul credito ai Consumatori (IEBCC). Salvo approvazione di Findomestic Banca S.p.A. per cui NewGroove.it opera quale intermediario del credito non in esclusiva.
The SoundMachines NS1 NanoBridge is a great little board to interface the NS1 Nanosynth to your eurorack devices.
SoundMachines NS1 NanoBridge includes 14x protected patch points that interfaces to 3,5mm jacks.
The SoundMachines NS1 NanoBridge is the definitive companion that allows the NS1 Nanosynth to interface to any eurorack or other modular system. With its 14 3,5mm jacks and optional protections on signals, the SoundMachines NS1 NanoBridge is the best solution to spread the nano strain.
You have, for each connection, a protected and unprotected nanopatch header. To have a fully working protected connection from the external system to the NS1 Nanosynth (that handles 0V to 5V voltages) connect the “0V” and “5V” nanopatch points to the same patch points on the RIGHTMOST connector header on the NS1 Nanosynth. This way you will limit the excursion of the incoming signal from 0V to 5V. To achieve this we put a resistor-diodes limiting circuit on each pin. Alternatively, and this is useful for two purposes: outgoing signals (from NS1 to modular) and incoming V/oct pitch, you can use the ‘unprotected’ header side.
A note about the compliance. Keep it always safe! if you don’t know what is the voltage range of the incoming signal use ALWAYS the ‘protected’ side, after having connected the 0V and 5V !!!!!!!!!!
The SoundMachines NS1 NanoBridge is shipped complete with four rubber feet.